ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System), Diagnostic DTC:B2793, B2794, B2797, B2798
| DTC Code | DTC Name |
|---|---|
| B2793 | Transponder Chip Malfunction |
| B2794 | Unmatched Encryption Code |
| B2797 | Communication Malfunction No. 1 |
| B2798 | Communication Malfunction No. 2 |
DESCRIPTION
-
DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.
-
DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.
-
DTC B2797 is stored when a key with a BCC malfunction is inserted into the ignition key cylinder.
-
DTC B2798 is stored when a key is inserted into the ignition key cylinder but a communication error occurs between the key and transponder key ECU assembly.
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
|---|---|---|---|
| B2793 | A transponder chip malfunction (1 trip detection logic*). |
|
Insert the key into the ignition key cylinder. |
| B2794 | A key with an incomplete key code is inserted into the ignition key cylinder (1 trip detection logic*). | ||
| B2797 | A key with a BCC malfunction is inserted into the ignition key cylinder (1 trip detection logic*). | ||
| B2798 | Key code identification cannot be completed within the specified time (1 trip detection logic*). |
-
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation When Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC Code | Data List and Active Test |
|---|---|
| B2793 | Abnormal Status |
| B2794 | Different Encrypt Code |
| B2797 | BCC Malfunction |
| B2798 | Frame Error |
CAUTION / NOTICE / HINT
Note
-
When the key is replaced, refer to the Service Bulletin.
-
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
PROCEDURE
-
CLEAR DTC
-
Clear the DTCs Click here.
NEXT 
-
-
CHECK FOR DTC
-
Check for DTCs using all registered keys Click here.
Tech Tips
If a DTC is stored, check for DTCs with the next key after clearing the DTCs.
OK DTC B2793, B2974, B2797 or B2798 is not output. Result Result Proceed to OK A NG (all keys) B NG (any key) C
A 
USE SIMULATION METHOD TO CHECK Click here
B
REPLACE TRANSPONDER KEY ECU ASSEMBLY
C
REPLACE KEY THAT CANNOT START ENGINE
-