FRONT DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT UPPER ARMREST BASE PANEL LH (for Driver Side)

    Click here

  2. REMOVE FRONT UPPER ARMREST BASE PANEL RH (for Front Passenger Side)

    Tech Tips

    Use the same procedure described for the LH side Click here.

  3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  4. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  5. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  6. REMOVE FRONT DOOR GLASS RUN

    Click here

  7. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  8. REMOVE HOLE PLUG

    Click here

  9. REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)

    A005MDC

    1. Using a "TORX" socket wrench T30, remove the screw and the front door lock cylinder assembly.

  10. REMOVE FRONT DOOR LOCK ASSEMBLY


    1. A005IV8

      Using a "TORX" socket wrench T30, remove the 3 screws.

    2. A005LGDE01
      Text in Illustration
      *1 Front Door Lock Open Rod
      A005GO2 Slide Direction

      Slide the front door lock assembly downward, and remove the front door lock assembly from the front door lock open rod.

    3. A005JUL

      Remove the door lock wire harness seal from the front door lock assembly.

  11. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY


    1. A005I5TE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, disengage the 7 claws.

    2. A005H62

      Remove the front door lock remote control cable assembly from the front door lock assembly.

  12. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY


    1. A005L3N

      Remove the front door inside locking cable assembly from the front door lock assembly.