TRANSMITTER BATTERY(w/ Entry and Start System) REPLACEMENT

PROCEDURE


  1. REMOVE TRANSMITTER BATTERY

    Note

    Take extra care when handling these precision electronic components.


    1. A005HBPE01
      Text in Illustration
      *1 Release Hook Knob
      *2 Mechanical Key

      Push the release hook knob and extract the mechanical key.

    2. A005J5OE01
      Text in Illustration
      *1 Protective Tape
      *2 Transmitter Housing Cover

      Insert a screwdriver with its tip wrapped in protective tape, pry apart the transmitter housing cover.

    3. A005HQ4E03
      Text in Illustration
      *1 Protective Tape
      *2 Transmitter Battery

      Insert a precision screwdriver with its tip wrapped in protective tape into the gap and gently remove the transmitter battery (lithium battery: CR1632).

      Note


      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

      • Do not push the terminals with your finger.

      • Do not forcibly pry up the battery. The terminals may be damaged.

      • Do not touch the battery with wet hands. Water may cause rust.

      • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

  2. INSTALL TRANSMITTER BATTERY


    1. A005GK3E01
      Text in illustration
      *1 Transmitter Battery

      Install a new transmitter battery (lithium battery: CR1632) with the positive (+) side facing upward, as shown in the illustration.

      Note


      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

      • Do not bend the transmitter battery electrode during insertion.

      • Keep the transmitter cover interior free of dust and oil.

    2. A005JMTE01
      Text in Illustration
      *1 Transmitter Housing Cover

      Install the transmitter housing cover by pressing down on it as shown in the illustration.

    3. A005MANE01
      Text in Illustration
      *1 Mechanical Key

      Insert the mechanical key into the transmitter.

    4. Press one of the transmitter switches and check that the LED illuminates.

      OK
      Transmitter LED illuminates when switch is pressed.