KEY REMINDER WARNING SYSTEM(w/o Entry and Start System) DATA LIST / ACTIVE TEST


  1. READ DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time

    Note

    In the table below, the values listed under Normal Condition are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Turn the ignition switch off.

    2. Connect the intelligent tester to the DLC3

    3. Turn the ignition switch to ON.

    4. Turn the intelligent tester on.

    5. Enter the following menus: Body / Main Body / Data List.

    6. According to the display on the tester, read the Data List.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Key Unlock Warning SW

      Unlock warning switch signal

      /ON or OFF

      ON: Key is in ignition key cylinder

      OFF: No key is in ignition key cylinder

      		 -
      ACC SW

      Ignition Switch ACC Signal

      / ON or OFF

      ON: Ignition Switch Acc

      OFF: Ignition Switch off

      		 -
      IG SW

      Ignition Switch ON Signal

      / ON or OFF

      ON: Ignition Switch ON

      OFF: Ignition Switch off

      		 -
      FR Door Courtesy

      Front RH door courtesy switch signal

      / ON or OFF

      ON: Front RH door closed

      OFF: Front RH door opened

      		 -
      FL Door Courtesy

      Front LH door courtesy switch signal

      / ON or OFF

      ON: Front LH door closed

      OFF: Front LH door opened

      		 -