WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System) No Answer-Back

DESCRIPTION

In some cases, wireless door lock control functions are normal but the hazard warning light and/or wireless door lock buzzer*1 answer-back function(s) does not operate. In such cases, the hazard warning light and wireless door lock buzzer signals output from the main body ECU (multiplex network body ECU) may be malfunctioning.


WIRING DIAGRAM

A005J9XE03

CAUTION / NOTICE / HINT

Note

Troubleshooting should be started after confirming that the customize status of the answer-back function has been switched on.

PROCEDURE


  1. CHECK WIRELESS DOOR LOCK CONTROL FUNCTIONS


    1. Check the wireless door lock control function by the electrical key transmitter.

      Result
      Result Proceed to
      Wireless door lock/unlock operates normally. A
      Wireless door lock/unlock does not operate normally. B

    B
    A
  2. READ VALUE USING INTELLIGENT TESTER (DOOR LOCK POSITION SWITCH)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body /Main Body / Data List.

    5. Read the Data List according to the display on the intelligent tester.

      Main Body (Main Body ECU (Multiplex Network Body ECU))
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      FL Door Lock Pos Front LH door lock position switch signal / ON or OFF

      ON: Front LH side door unlocked

      OFF: Front LH side door locked

      -
      FR Door Lock Pos Front RH door lock position switch signal / ON or OFF

      ON: Front RH side door unlocked

      OFF: Front RH side door locked

      -
      RL-Door Lock Pos Rear left door lock position switch signal / ON or OFF

      ON: Rear LH side door unlocked

      OFF: Rear LH side door locked

      -
      RR-Door Lock Pos Rear right door lock position switch signal / ON or OFF

      ON: Rear RH side door unlocked

      OFF: Rear RH side door locked

      -
      OK
      On the intelligent tester screen, the display changes between ON and OFF as shown in the table above.

    NG
    OK
  3. CHECK WIRELESS ANSWER-BACK OPERATION


    1. Check the wireless answer-back operation by wireless door lock control function.

      Result
      Result Proceed to
      Only hazard warning light answer-back does not occur. A
      Only wireless door lock buzzer answer-back does not occur. B

    B
    A
  4. CHECK HAZARD WARNING LIGHT OPERATION


    1. Check that the hazard warning lights flash continuously when the hazard warning signal switch is pressed.

      OK
      Hazard warning lights flash continuously.

    OK
    NG