READ DATA LIST
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Tech Tips
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Communication D-Door Motor | Connection status between power window regulator motor assembly RH (for driver side)*1 or power window regulator motor assembly LH (for driver side)*2 and main body ECU (multiplex network body ECU) / OK or STOP | OK: Connection STOP: No connection |
When there is a malfunction, a DTC is stored. |
| Communication Slide Roof*3 | Connection status between sliding roof drive gear assembly and main body ECU (multiplex network body ECU) / OK or STOP | OK: Connection STOP: No connection |
When there is a malfunction, a DTC is stored. |
| Communication Double Locking*4 | Connection status between double lock door control relay assembly and main body ECU (multiplex network body ECU) / OK or STOP | OK: Connection STOP: No connection |
When there is a malfunction, a DTC is stored. |
| Number of Trouble Codes | Number of trouble codes / Min.: 0, Max.: 255 | Number of stored DTCs displayed | - |
*1 : for RHD
*2 : for LHD
*3 : w/ Sliding Roof System
*4 : w/ Double Locking Function