REAR VIEW MONITOR SYSTEM PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. EXPRESSIONS OF IGNITION SWITCH


    1. The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression

      Ignition Switch

      (Position)

      Engine Switch

      (Condition)
      Ignition Switch off LOCK Off (LOCK)
      Ignition Switch ON ON On (IG)
      Ignition Switch ACC ACC On (ACC)
      Engine start START On (START)

  3. NOTES FOR REAR TELEVISION CAMERA


    1. Notes for the rear television camera assembly.


      1. The rear view monitor system may not function properly if subjected to a severe blow by any hard object.

      2. Do not scrub the camera. Scrubbing may scratch the cover and affect the image. Prevent organic solvents, waxes, bond removing solvents or glass coating from adhering to the cover. If such material adheres to the cover, clean it off immediately and wash with water.

      3. Exposing the camera to a sudden temperature change may affect proper functioning of the camera.

      4. A clear image may not appear if the camera is dirty with snow, mud, etc. In that case, wash it with water and wipe off the lens. Use a detergent to remove dirt if necessary.

    2. Images are difficult to discern even in normal conditions if:


      1. Noise may occur in the image depending on electrical devices used in the cabin.

      2. Noise may occur in the image if accessories that generate radio waves have been installed.

      3. Noise may occur in the image if the outer mirror switch assembly is operated.

      4. The camera screen is frosted over (the image immediately after turning the ignition switch to ON may be blurred or darker than normal).

      5. The camera lens is dirty with snow, mud, etc.

      6. A strong beam of light, such as a sunbeam or headlight, hits the camera.

      7. It is too dark around the camera (at night etc.).

      8. The ambient temperature around the camera is either too high or too low.

      9. The vehicle is tilted at a steep angle.

      10. The ambience of the camera is too bright.