REAR DOOR SPEAKER REMOVAL

PROCEDURE


  1. REMOVE REAR DOOR ARMREST UPPER BASE PANEL

    Click here

  2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Rear Power Window)

    Click here

  3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  4. REMOVE REAR SPEAKER ASSEMBLY

    A005LFE

    1. Disconnect the connector.

    2. Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.).

    3. Move the drill around the rivet head circumference to cut the flange.

      CAUTION:

      Be careful. The cut rivet is very hot.

      Note

      Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

    4. After drilling out the flange, continue drilling to push out the shards on the drill.

    5. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

    6. Disengage the 2 claws and remove the rear speaker assembly.