AUDIO AND VISUAL SYSTEM(for Radio and Display Type) USB Device or "iPod" cannot Charge

WIRING DIAGRAM

A005IZLE04
*a RADIO AND DISPLAY ASSEMBLY
*b NO. 1 STEREO JACK ADAPTER ASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • USB device or "iPod" may not be able to charge on vehicle when its battery is particularly depleted.

  • For vehicles equipped with an Extension Module, refer to optional equipment's manuals.

PROCEDURE


  1. REPLACE USB DEVICE OR "iPod"


    1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

    2. Turn the ignition switch off.

      Tech Tips

      When this malfunction occurs, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

    3. Turn the ignition switch to ACC.

    4. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

      OK
      USB device or "iPod" charges.

    OK

    USB DEVICE OR "iPod" WAS DEFECTIVE

    NG

  2. INSPECT RADIO AND DISPLAY ASSEMBLY


    1. A005JZ4E01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

      Disconnect the F53 No. 1 stereo jack adapter assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      F53-1 - F53-4 Always 5 V

    OK

    REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY Click here

    NG

  3. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY ASSEMBLY - NO. 1 STEREO JACK ADAPTER)


    1. Disconnect the F89 radio and display assembly connector.

    2. Disconnect the F53 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open)
      Tester Connection Condition Specified Condition
      F89-1 - F53-1 Always Below 1 Ω
      F89-4 - F53-4 Always Below 1 Ω
      Standard Resistance (Check for Short)
      Tester Connection Condition Specified Condition
      F89-1 - Body ground Always 10 kΩ or higher
      F89-4 - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR