STEERING COLUMN ASSEMBLY(for RHD) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. POSITION FRONT WHEELS FACING STRAIGHT AHEAD

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  3. REMOVE STEERING PAD

    Click here

  4. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  5. REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)


    1. A005JOM

      Disengage the 4 claws and remove the steering column cover support.

  6. REMOVE LOWER STEERING COLUMN COVER


    1. A005GFG

      Remove the 3 screws, disengage the 4 claws, release the tilt lever and remove the lower steering column cover.

  7. REMOVE UPPER STEERING COLUMN COVER


    1. A005MJW

      Disengage the claw and remove the upper steering column cover.

  8. REMOVE COMBINATION SWITCH ASSEMBLY


    1. Disconnect all connectors from the combination switch assembly.

    2. A005IO0E01
      Text in Illustration
      *a Loosen The Clamp
      *a Raise The Claw

      Use pliers to hold the clamp and raise the claw with a screwdriver. Remove the combination switch assembly from the steering column assembly.

  9. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY

    Click here

  10. REMOVE COLUMN HOLE COVER SILENCER SHEET


    1. A005IBH

      Remove the floor carpet and 2 clips and remove the column hole cover silencer sheet.

  11. REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY


    1. A005GSWE03
      Text in Illustration
      *1 No. 2 Steering Intermediate Shaft Assembly
      *2 Steering Sliding Yoke Sub-assembly
      *a Matchmark

      Place matchmarks on the No. 2 steering intermediate assembly and steering column assembly.

    2. Place matchmarks on the steering sliding yoke sub-assembly and steering gear assembly.

    3. Loosen bolt A.

    4. Loosen bolt C.

    5. Remove bolt B and detach the steering sliding yoke sub-assembly from the steering gear assembly.

  12. REMOVE STEERING COLUMN ASSEMBLY


    1. A005IC8

      Separate the wire harness clamp from the power steering ECU assembly.

    2. Disconnect the 2 steering column assembly connectors from the power steering ECU assembly.

    3. Disconnect all connectors and detach all wire harness clamps from the steering column assembly.

    4. A005MAP

      Remove the bolt and the 2 nuts and remove the steering column assembly from the instrument panel reinforcement assembly.