PARKING BRAKE CABLE(for Rear Disc Brake) INSTALLATION

PROCEDURE


  1. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY


    1. A005JEN

      Install the casing cap clip onto the rear disc brake cylinder guide.

    2. Connect the cable end to the rear disc brake cylinder operation lever.

    3. Install cable clamp B onto the rear axle beam.

      Note

      Securely install the clamp.

      Tech Tips

      When reusing the parking brake cable assembly, replace cable clamp B with a new part.

    4. Tighten the 4 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    5. Pass the parking brake cable through a new cable clamp A, and then install cable clamp A onto the stud bolt.

      Note

      Securely install the clamp.

      A005KTOE01

  2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  3. INSTALL PARKING BRAKE LEVER SUB-ASSEMBLY

    Click here

  4. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }