REAR BRAKE FLEXIBLE HOSE(for Drum Type) INSTALLATION

PROCEDURE

1. INSTALL REAR FLEXIBLE HOSE

   
   

   1. Install the flexible hose with 2 new clips onto the axle beam.

   2. Using a union nut wrench, install the 2 brake tubes onto the flexible hose while holding the flexible hose with a wrench.

      Torque:

      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

2. FILL RESERVOIR WITH BRAKE FLUID

   Click here

3. BLEED CLUTCH LINE (for Manual Transmission)

   
   

   • for 1NR-FE Click here

   • for 1ND-TV Click here

4. BLEED CLUTCH LINE (for Multi-Mode Manual Transaxle)

   (See page CLUTCH > CLUTCH SYSTEM (for EC65A) > BLEEDING > BLEED CLUTCH LINE)

5. BLEED BRAKE MASTER CYLINDER SUB-ASSEMBLY

   Click here

6. BLEED BRAKE LINE

   Click here

7. BLEED BRAKE ACTUATOR ASSEMBLY (w/ VSC)

   Click here

8. INSPECT FOR BRAKE FLUID LEAK

9. INSPECT FLUID LEVEL

   Click here

10. INSTALL REAR WHEEL

    Torque:

    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }