BRAKE BOOSTER(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL BRAKE BOOSTER ASSEMBLY


    1. Install a new gasket onto the brake booster assembly.

    2. Temporary install the brake booster assembly with the 4 nuts.

    3. A005KFDE01

      Tighten the 4 nuts as shown in the illustration.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

    4. Install the wire harness clamp.

    5. Install the wire harness bracket with the bolt. (for 1NR-FE)

      Torque:
      8.4 N*m  { 85 kgf*cm, 74 in.*lbf }

    6. Connect the vacuum hose to the vacuum check valve with the clip.

  2. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS

    Click here

  3. INSTALL AIR CLEANER AND HOSE ASSEMBLY (for 1NR-FE)

    Click here

  4. INSTALL INLET NO. 1 AIR CLEANER (for 1NR-FE)

    Click here

  5. INSTALL OUTER COWL TOP PANEL

    Click here

  6. INSTALL LOWER COWL TOP REINFORCEMENT INNER

    Click here

  7. INSTALL COWL TOP INSIDE CORNER PANEL RH

    Click here

  8. INSTALL INNER COWL TOP TO COWL BRACE

    Click here

  9. INSTALL FRONT NO. 1 VENTILATOR SEAL

    Click here

  10. INSTALL FRONT AIR SHUTTER SEAL RH

    Tech Tips

    Use the same procedure as for the LH side.

  11. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE (for 1NZ-FE)

    Click here

  12. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

    Click here

  13. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY

    Click here