STEERING ANGLE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY


    1. Confirm that the ignition switch is turned off.

    2. Confirm that the negative (-) battery terminal is disconnected.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Confirm that the front tires face straight forward.

    4. Confirm that the turn signal switch is in the neutral position.

      Note

      Perform the operation when the turn signal switch is in the neutral position. Otherwise, the turn signal pin will break.

    5. Engage the 3 claws and install the spiral cable sub-assembly.

      Note

      Pull the lock pin out before installing the steering wheel when replacing the spiral cable sub-assembly with a new one.

    6. A005H0Q

      Connect the airbag connector.

    7. Connect each connector to the spiral with sensor cable sub-assembly.

  2. INSTALL UPPER STEERING COLUMN COVER

    Click here

  3. INSTALL LOWER STEERING COLUMN COVER

    Click here

  4. INSTALL STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

    Click here

  5. ADJUST SPIRAL CABLE

    Click here

  6. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  8. CHECK SRS WARNING LIGHT

    Click here