FRONT SPEED SENSOR INSTALLATION

PROCEDURE


  1. INSTALL FRONT SPEED SENSOR


    1. Install the speed sensor onto the steering knuckle with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Check that the speed sensor tip and installation portion are free of foreign matter.

      • Install the speed sensor without turning it from its original installation angle.

    2. Install the clamp onto the shock absorber with the bolt.

      Torque:
      29 N*m  { 300 kgf*cm, 22 ft.*lbf }

    3. Install the clamp onto the body with the bolt.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    4. Engage the 3 clamps onto the body.

    5. Connect the speed sensor connector.

    6. Engage the clamp onto the body.

  2. INSTALL FRONT FENDER LINER


    1. Install the front fender liner with 4 grommets.

    2. Install the 7 clips and 2 screws.

    3. A005H2V

      Install the pin hold clip.

      Note

      Install the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.

  3. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  4. CHECK ABS SENSOR SIGNAL

    Tech Tips