BRAKE BOOSTER(for RHD) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

   Click here

2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

   Click here

3. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (for 1NZ-FE)

   Click here

4. REMOVE FRONT NO. 1 VENTILATOR SEAL

   Click here

5. REMOVE FRONT AIR SHUTTER SEAL RH

   Tech Tips

   Use the same procedure as for the LH side.

6. REMOVE INNER COWL TOP TO COWL BRACE

   Click here

7. REMOVE LOWER COWL TOP REINFORCEMENT INNER

   Click here

8. REMOVE COWL TOP INSIDE CORNER PANEL RH

   Click here

9. REMOVE OUTER COWL TOP PANEL

   Click here

10. REMOVE INLET NO. 1 AIR CLEANER (for 1NR-FE)

    Click here

11. REMOVE AIR CLEANER AND HOSE ASSEMBLY (for 1NR-FE)

    Click here

12. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

    Click here

13. REMOVE BRAKE BOOSTER ASSEMBLY

    
    

    1. Slide the clip and disconnect the vacuum hose from the check valve.

    2. 

       Remove the bolt and separate the wire harness bracket. (for 1NR-FE)

    3. 

       Remove the wire harness clamp and 4 nuts and remove the brake booster assembly.

       Note

       Do not damage the brake tubes.

    4. Remove the gasket from the brake booster assembly.