VEHICLE STABILITY CONTROL SYSTEM CHECK FOR INTERMITTENT PROBLEMS

CHECK FOR INTERMITTENT PROBLEMS

1. Turn the ignition switch off.

2. Connect the intelligent tester to the DLC3.

3. Turn the ignition switch to ON.

4. Turn the intelligent tester on.

5. 

   Text in Illustration

   *a	Harness Signal
   *b	Tester Display
   *c	OK
   *d	Momentary interruption
   *e	ERROR
   *f	NORMAL
   *g	1 Second

   Follow the directions on the intelligent tester to display the Data List and select areas where momentary interruptions should be monitored.

   Tech Tips

   
   

   • A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).

   • If the Error display remains displayed, measure the resistance between the ECUs and sensors, or between ECUs.

   • The Error display on the intelligent tester will remain displayed for 1 second after the harness signal changes from momentary interruption (open circuit) to the normal condition.

   ABS/VSC/TRC

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   FR Speed Open	FR speed sensor open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   FL Speed Open	FL speed sensor open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   RR Speed Open	RR speed sensor open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   RL Speed Open	RL speed sensor open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   EFI Communication Open	EFI communication open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   Yaw Rate Open	Yaw rate sensor open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   Deceleration Open	Acceleration sensor open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   Steering Open	Steering angle sensor open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   Master Cylinder Open	Master cylinder pressure sensor open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   IG Voltage Value Decreased	IG voltage value decrease detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   IG Voltage Value Increased	IG voltage value increase detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   FR Speed Sensor Voltage Open	Front speed sensor RH voltage open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   FL Speed Sensor Voltage Open	Front speed sensor LH voltage open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   RR Speed Sensor Voltage Open	Rear speed sensor RH voltage open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   RL Speed Sensor Voltage Open	Rear speed sensor LH voltage open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   M/C Pressure Sensor Noise	Master cylinder pressure sensor noise detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   Yaw Rate Sensor Voltage Open	Yaw rate sensor voltage open detection/Error or Normal	Error: Momentary interruption Normal: Normal	-
   EFI Communication Invalid	EFI communication invalid detection/Error or Normal	Error: Momentary interruption Normal: Normal	-

6. 

   Text in Illustration

   *a	Shake Slightly
   *b	Vibrate Slightly

   While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

   Tech Tips

   If the display changes, the connector and/or the wire harness has caused a momentary interruption of the circuit. Repair or replace the connector and/or wire harness as one of them is faulty.