DATA LIST
Tech Tips
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ABS Warning Light | ABS warning light/ON or OFF | ON: Warning light ON OFF: Warning light OFF |
- |
| Brake Warning Light | Brake warning light/ON or OFF | ON: Warning light ON OFF: Warning light OFF |
- |
| Stop Light SW | Stop light switch/ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released |
- |
| Parking Brake SW | Parking brake switch/ON or OFF | ON: Parking brake applied OFF: Parking brake released |
- |
| Number of IG ON | Number of ignition switch to ON after entering inspection mode/Min.: 0, Max.: 255 | - | - |
| Deceleration Sensor | Acceleration sensor/Min.: -18.525 m/s2, Max.: 18.387m/s2 |
- | During deceleration/acceleration: Changes continuously |
| Forward and Rearward G | Forward and backward G/Min.: -25.11 m/s2, Max.: 24.91 m/s2 |
- | During deceleration/acceleration: Changes continuously |
| FR Wheel Speed | FR wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h |
When driving at constant speed: No large fluctuations |
| FL Wheel Speed | FL wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h |
When driving at constant speed: No large fluctuations |
| RR Wheel Speed | RR wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h |
When driving at constant speed: No large fluctuations |
| RL Wheel Speed | RL wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h |
When driving at constant speed: No large fluctuations |
| Vehicle Speed | Maximum wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h |
When driving at constant speed: No large fluctuations |
| FR Wheel Acceleration | FR wheel acceleration/Min.: -200.84 m/s2, Max.: 199.27 m/s2 |
- | During deceleration/acceleration: Changes continuously |
| FL Wheel Acceleration | FL wheel acceleration/Min.: -200.84 m/s2, Max.: 199.27 m/s2 |
- | During deceleration/acceleration: Changes continuously |
| RR Wheel Acceleration | RR wheel acceleration/Min.: -200.84 m/s2, Max.: 199.27 m/s2 |
- | During deceleration/acceleration: Changes continuously |
| RL Wheel Acceleration | RL wheel acceleration/Min.: -200.84 m/s2, Max.: 199.27 m/s2 |
- | During deceleration/acceleration: Changes continuously |
| FR Wheel ABS Ctrl Status | FR wheel ABS control status/ON or OFF | ON: During the control | - |
| FL Wheel ABS Ctrl Status | FL wheel ABS control status/ON or OFF | ON: During the control | - |
| RR Wheel ABS Ctrl Status | RR wheel ABS control status/ON or OFF | ON: During the control | - |
| RL Wheel ABS Ctrl Status | RL wheel ABS control status/ON or OFF | ON: During the control | - |
| RR Wheel EBD Ctrl Status | RR wheel EBD control status/ON or OFF | ON: During the control | - |
| RL Wheel EBD Ctrl Status | RL wheel EBD control status/ON or OFF | ON: During the control | - |
| Solenoid Relay | ABS solenoid relay/ON or OFF | ON: Solenoid relay ON OFF: Solenoid relay OFF |
- |
| ECB Motor Relay | ABS motor relay/ON or OFF | ON: Motor relay ON OFF: Motor relay OFF |
Item is displayed on tester but not used. |
| ABS Solenoid (SFRH) | ABS solenoid (SFRH)/ON or OFF | ON: Operates | - |
| ABS Solenoid (SFRR) | ABS solenoid (SFRR)/ON or OFF | ON: Operates | - |
| ABS Solenoid (SFLH) | ABS solenoid (SFLH)/ON or OFF | ON: Operates | - |
| ABS Solenoid (SFLR) | ABS solenoid (SFLR)/ON or OFF | ON: Operates | - |
| ABS Solenoid (SRRH) | ABS solenoid (SRRH)/ON or OFF | ON: Operates | - |
| ABS Solenoid (SRRR) | ABS solenoid (SRRR)/ON or OFF | ON: Operates | - |
| ABS Solenoid (SRLH) | ABS solenoid (SRLH)/ON or OFF | ON: Operates | - |
| ABS Solenoid (SRLR) | ABS solenoid (SRLR)/ON or OFF | ON: Operates | - |
| FR Speed Open | FR speed sensor open detection/Error or Normal | Error: Momentary interruption Normal: Normal |
- |
| FL Speed Open | FL speed sensor open detection/Error or Normal | Error: Momentary interruption Normal: Normal |
- |
| RR Speed Open | RR speed sensor open detection/Error or Normal | Error: Momentary interruption Normal: Normal |
- |
| RL Speed Open | RL speed sensor open detection/Error or Normal | Error: Momentary interruption Normal: Normal |
- |
| EFI Communication Open | EFI communication open detection/Error or Normal | Error: Momentary interruption Normal: Normal |
- |
| IG1 Voltage Value | IG1 voltage value/Min.: 0 V, Max.: 20 V | - | - |
| MT Voltage Value | Motor driving monitor voltage/Min.: 0 V, Max.: 20 V | - | - |
| Number of DTC | Number of DTC recorded/Min.: 0, Max.: 255 | - | - |
| IG Voltage Value Decreased | IG voltage value decrease detection/Error or Normal |
Error: Momentary interruption Normal: Normal |
- |
| IG Voltage Value Increased | IG voltage value increase detection/Error or Normal |
Error: Momentary interruption Normal: Normal |
- |
| FR Speed Sensor Voltage Open | Front speed sensor RH voltage open detection/Error or Normal |
Error: Momentary interruption Normal: Normal |
- |
| FL Speed Sensor Voltage Open | Front speed sensor LH voltage open detection/Error or Normal |
Error: Momentary interruption Normal: Normal |
- |
| RR Speed Sensor Voltage Open | Rear speed sensor RH voltage open detection/Error or Normal |
Error: Momentary interruption Normal: Normal |
- |
| RL Speed Sensor Voltage Open | Rear speed sensor LH voltage open detection/Error or Normal |
Error: Momentary interruption Normal: Normal |
- |
| Body ECU Communication Open | Body ECU Communication open detection/Error or Normal |
Error: Momentary interruption Normal: Normal |
- |
ACTIVE TEST
Tech Tips
Using the intelligent tester to perform Active Tests allows relays, VSV, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| ABS Warning Light | ABS warning light | Warning light ON/OFF | Observe combination meter |
| Brake Warning Light | Brake warning light | Warning light ON/OFF | Observe combination meter |
| Solenoid Relay | ABS solenoid relay | Relay ON/OFF | - |
| Motor Relay | ABS motor relay | Relay ON/OFF | Operating sound of motor can be heard. |
| ABS Solenoid (SRLR) | ABS solenoid (SRLR) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. |
| ABS Solenoid (SRLH) | ABS solenoid (SRLH) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. |
| ABS Solenoid (SRRR) | ABS solenoid (SRRR) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. |
| ABS Solenoid (SRRH) | ABS solenoid (SRRH) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. |
| ABS Solenoid (SFLR) | ABS solenoid (SFLR) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. |
| ABS Solenoid (SFLH) | ABS solenoid (SFLH) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. |
| ABS Solenoid (SFRR) | ABS solenoid (SFRR) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. |
| ABS Solenoid (SFRH) | ABS solenoid (SFRH) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. |