TIRE PRESSURE WARNING RECEIVER INSTALLATION

PROCEDURE

1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

   
   

   1. Engage the 2 hooks to temporarily install the tire pressure warning ECU and receiver.

   2. Install the bolt.

      Torque:

      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

   3. Connect the connector to the tire pressure warning ECU and receiver.

2. INSTALL ROOF SIDE INNER GARNISH LH

   Click here

3. CONNECT REAR NO. 1 OUTER SEAT BELT ASSEMBLY LH

   Click here

4. INSTALL REAR SEAT ASSEMBLY LH

   Click here

5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

   Click here

6. INSTALL RECLINING REMOTE CONTROL BEZEL LH

   Click here

7. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

   Click here

8. INSTALL DECK SIDE TRIM BOX LH (w/o Rear Deck Floor Box)

   Click here

9. INSTALL LUGGAGE ROOM BOX SEPARATOR

   Click here

10. INSTALL REAR FLOOR REAR MAT (w/o Rear Deck Floor Box)

    Click here

11. INSTALL REAR DECK TRIM COVER

    Click here

12. INSTALL BACK DOOR WEATHERSTRIP

    Click here

13. INSTALL REAR DECK FLOOR BOX (w/ Rear Deck Floor Box)

    Click here

14. INSTALL DECK BOARD ASSEMBLY

    Click here

15. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

16. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

18. REGISTER TRANSMITTER ID

    Click here

19. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

20. PERFORM INITIALIZATION

    Click here