TIRE PRESSURE WARNING RECEIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative(-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative(-) battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  5. REMOVE DECK BOARD ASSEMBLY

    Click here

  6. REMOVE REAR DECK FLOOR BOX (w/ Rear Deck Floor Box)

    Click here

  7. REMOVE BACK DOOR WEATHERSTRIP

    Click here

  8. REMOVE REAR DECK TRIM COVER

    Click here

  9. REMOVE REAR FLOOR REAR MAT (w/o Rear Deck Floor Box)

    Click here

  10. REMOVE LUGGAGE ROOM BOX SEPARATOR

    Click here

  11. REMOVE DECK SIDE TRIM BOX LH (w/o Rear Deck Floor Box)

    Click here

  12. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

  13. REMOVE RECLINING REMOTE CONTROL BEZEL LH

    Click here

  14. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  15. REMOVE REAR SEAT ASSEMBLY LH

    Click here

  16. DISCONNECT REAR NO. 1 OUTER SEAT BELT ASSEMBLY LH

    Click here

  17. REMOVE ROOF SIDE INNER GARNISH LH

    Click here

  18. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER


    1. A005GIO

      Disconnect the connector from the tire pressure warning ECU and receiver.

    2. Remove the bolt.

    3. Disengage the 2 hooks to remove the tire pressure warning ECU and receiver.