TIRE PRESSURE WARNING SYSTEM Tire Pressure Warning Light Circuit

DESCRIPTION

If the tire pressure warning ECU and receiver detects any problems, the tire pressure warning light blinks (stays on after blinking for 1 minute) and tire pressure monitoring is canceled at the same time. At this time, the ECU stores a DTC in memory.

Connecting terminals TC and CG of the DLC3 makes the tire pressure warning light blink to output DTCs.

The tire pressure warning ECU and receiver sends the tire pressure warning light illumination request signal to the main body ECU (multiplex network body ECU) via a direct line. The main body ECU (multiplex network body ECU) then sends the signal to the combination meter assembly via CAN communication.

WIRING DIAGRAM

A005LV1E02
*a Main Body ECU (Multiplex Network Body ECU)
*b Combination Meter Assembly
*c Tire Pressure Warning ECU and Receiver
*d CAN Communication Line

CAUTION / NOTICE / HINT

Note


  • When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

  • It is necessary to perform initialization (See page ) after registration Click here of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU and/or one of the valve and transmitters has been replaced.

PROCEDURE


  1. CHECK FOR DTC (CAN COMMUNICATION SYSTEM)


    1. Check the CAN communication system Click here.

      OK
      The CAN communication system is normal.

    NG

    GO TO CAN COMMUNICATION SYSTEM Click here

    OK

  2. CHECK DTC OUTPUT (B1247)


    1. Clear the DTCs Click here.

    2. Turn the ignition switch off.

    3. Turn the ignition switch to ON.

    4. Check for DTCs Click here.

      OK
      DTC B1247 is not output.

    NG

    GO TO DTC B1247 Click here

    OK

  3. CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)


    1. Turn the ignition switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    6. Check the condition of the tire pressure warning light by using the GTS.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Indicat. Tire Pressure Warning System Tire pressure warning light Tire pressure warning light OFF or ON Confirm that the vehicle is stopped, engine idling
      OK
      The tire pressure warning light turns on or off in accordance with the GTS operation.

    OK

    REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER Click here

    NG

    GO TO METER / GAUGE SYSTEM Click here