FRONT DRIVE SHAFT ASSEMBLY(for 1NZ-FE) INSTALLATION

PROCEDURE

1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

   Click here

2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

   Tech Tips

   Use the same procedure for the RH side as for the LH side.

3. INSTALL FRONT AXLE ASSEMBLY LH

   
   

   1. Push the front axle out of the vehicle to align the spline of the drive shaft with the front axle and insert the front axle.

      Note

      
      

      • Do not push the front axle further out of the vehicle than is necessary.

      • Do not damage the outboard joint boot.

      • Check for any foreign matter on the speed sensor rotor and insertion part.

      • Do not damage the speed sensor rotor.

4. INSTALL FRONT AXLE ASSEMBLY RH

   Tech Tips

   Use the same procedure for the RH side as for the LH side.

5. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH

   Click here

6. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH

   Tech Tips

   Use the same procedure for the RH side as for the LH side.

7. INSTALL TIE ROD END SUB-ASSEMBLY LH

   Click here

8. INSTALL TIE ROD END SUB-ASSEMBLY RH

   Tech Tips

   Use the same procedure for the RH side as for the LH side.

9. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

   Click here

10. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

11. INSTALL FRONT SPEED SENSOR LH

    Click here

12. INSTALL FRONT SPEED SENSOR RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

13. INSTALL FRONT AXLE SHAFT NUT LH

    Click here

14. INSTALL FRONT AXLE SHAFT NUT RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

15. ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click here

16. INSPECT CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click here

17. INSPECT FOR OIL LEAK

18. INSTALL ENGINE UNDER COVER RH

    Click here

19. INSTALL ENGINE UNDER COVER LH

    Click here

20. INSTALL FRONT WHEEL

    Torque:

    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

21. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here