FRONT DRIVE SHAFT ASSEMBLY(for 1ND-TV) REMOVAL

PROCEDURE


  1. REMOVE CENTER ENGINE UNDER COVER

    Click here

  2. REMOVE ENGINE UNDER COVER RH

    Click here

  3. REMOVE ENGINE UNDER COVER LH

    Click here

  4. DRAIN TRANSAXLE OIL (for Manual Transaxle)

    Click here

  5. DRAIN TRANSAXLE OIL (for Multi-Mode Manual Transaxle)

    See page Cleck here MULTI-MODE MANUAL TRANSAXLE (EC65A) > MULTI-MODE MANUAL TRANSAXLE OIL > REPLACEMENT > DRAIN MANUAL TRANSAXLE OIL

  6. REMOVE FRONT WHEEL

  7. REMOVE FRONT AXLE SHAFT NUT LH

    A005GG6E01

    1. Using SST and a hammer, release the staked part of the front axle shaft nut.

      SST
      09930-00010

      Note


      • Insert SST into the groove with the flat surface facing up.

      • Do not damage the tip of SST using grinders.

      • Completely unstake the staked part before removing the front axle shaft nut.

      • Do not damage the threads of the front drive shaft.

    2. Using a 30 mm socket wrench, remove the front axle shaft nut.

  8. REMOVE FRONT AXLE SHAFT NUT RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  9. SEPARATE FRONT SPEED SENSOR LH

    A005H9Z

    1. Remove the bolt and separate the speed sensor and flexible hose.

    2. A005ITB

      Remove the bolt and separate the speed sensor from the steering knuckle.

      Note


      • Keep the speed sensor tip and installation portion free of foreign matter.

      • Remove the speed sensor without turning it from its original installation angle.

  10. SEPARATE FRONT SPEED SENSOR RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  11. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH

    Click here

  12. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  13. SEPARATE TIE ROD END SUB-ASSEMBLY LH

    Click here

  14. SEPARATE TIE ROD END SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  15. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH

    Click here

  16. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  17. SEPARATE FRONT AXLE ASSEMBLY LH

    Click here

  18. SEPARATE FRONT AXLE ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  19. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH


    1. A005GUHE04

      Using SST, remove the drive shaft as shown in the illustration.

      SST
      09520-01010
      09520-24010   ( 09520-32040 )

      Note


      • Do not damage the oil seal.

      • Do not damage the inboard joint boot.

      • Do not drop the drive shaft.

  20. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH


    1. A005LHQ

      Using a screwdriver and hammer, remove the drive shaft.

      Note


      • Do not damage the oil seal.

      • Do not damage the inboard joint boot.

      • Do not drop the drive shaft.

  21. FIX FRONT AXLE ASSEMBLY

    Click here