REAR COIL SPRING INSTALLATION

PROCEDURE


  1. INSTALL REAR COIL SPRING LH


    1. Install the coil spring insulator lower onto the axle beam.

    2. A005H6SE01
      Text in Illustration
      *a Fit

      Install the coil spring insulator upper so that its gap fits onto the end of coil spring.

    3. A005I3C

      Install the rear coil spring LH onto the axle beam.

      Text in Illustration
      A005H6N Paint Mark

      Note

      The paint mark of the coil spring should be towards the underside and rear side of the vehicle.

  2. INSTALL REAR COIL SPRING RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  3. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH


    1. Support the rear axle beam with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.

    2. Jack up the rear axle beam slowly, and provisionally install the shock absorber (lower side) with the bolt and nut onto the rear axle beam.

  4. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  5. INSTALL REAR FLEXIBLE HOSE LH


    1. Connect the rear flexible hose LH onto the axle beam with a new clip.

    2. Using a union nut wrench, install the brake tube.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

  6. INSTALL REAR FLEXIBLE HOSE RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  7. INSTALL SKID CONTROL SENSOR WIRE


    1. Install the skid control sensor wire onto the axle beam with the nut.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    2. Connect the skid control sensor wire connector.

  8. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  9. STABILIZE SUSPENSION

    Click here

  10. FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY

    Click here

  11. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

    Click here

  12. FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  13. FILL RESERVOIR WITH BRAKE FLUID

    Click here

  14. BLEED BRAKE MASTER CYLINDER SUB-ASSEMBLY

    Click here

  15. BLEED BRAKE LINE

    Click here

  16. BLEED BRAKE ACTUATOR ASSEMBLY (w/ VSC)

    Click here

  17. INSPECT FOR BRAKE FLUID LEAK

  18. INSPECT FLUID LEVEL

    Click here

  19. INSPECT REAR WHEEL ALIGNMENT

    Click here

  20. CHECK SPEED SENSOR SIGNAL