SHIFT PADDLE SWITCH INSPECTION

PROCEDURE


  1. INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

    A005LC4E12
    Text in Illustration
    *a

    Component without harness connected

    (Shift Paddle Switch LH)
    *b

    Component without harness connected

    (Shift Paddle Switch RH)

    1. Measure the resistance between each terminal when the shift paddle shift is moved to each position.

      Standard Resistance
      for LH:
      Tester Connection Condition Specified Condition
      2 (SFTD) - 3 (ECC) Pull continuously "-" (Down shift) Below 2.5 Ω
      Release "-" (Down shift) 1 MΩ or higher
      2 (SFTD) - 4 (ECC1) Pull continuously "-" (Down shift) Below 2.5 Ω
      Release "-" (Down shift) 1 MΩ or higher
      for RH:
      Tester Connection Condition Specified Condition
      3 (SFTU) - 2 (ECC1) Pull continuously "+" (Up shift) Below 2.5 Ω
      Release "+" (Up shift) 1 MΩ or higher

      If the resistance value are not as specified, replace the shift paddle switch (transmission shift switch assembly).