SHIFT LEVER INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

   
   
   1. 

      Text in Illustration

      *1	Nut
      *2	Lock
      *a	Turn
      *b	Push

      Turn the nut on the transmission control cable assembly and push in the lock.

   2. 

      Text in Illustration

      *1

      Lock

      Install the outer part of the transmission control cable assembly to the shift lever retainer. Check that the spring is positioned at "A" and push in the stopper.

      Tech Tips

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

   3. Install the cable end to the shift lock control unit assembly.

      Note

      
      

      • Check that the lock piece is pulled up.

      
      

      • Install the cable end all the way to the base of the pin.

2. INSTALL SHIFT LOCK CONTROL UNIT ASSEMBLY

   Note

   Check that the park/neutral position switch and the shift lever are in neutral.

   
   

   1. Install the shift lock control unit assembly with the 4 nuts.

      Torque:

      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

   2. Connect the 3 connectors and engage the 2 clamps to the shift lock control unit assembly.

3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

   
   

   1. Turn the shift lever knob sub-assembly clockwise to install the shift lever knob sub-assembly.

4. INSPECT SHIFT LEVER POSITION

   Click here

5. ADJUST SHIFT LEVER POSITION

   Click here

6. INSTALL LOWER INSTRUMENT PANEL CENTER FINISH PANEL

   Click here

7. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

   Click here

8. INSTALL NO. 1 METER HOOD CLUSTER

   Click here

9. INSTALL NO. 2 METER HOOD CLUSTER

   Click here

10. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here