BACK-UP LIGHT SWITCH INSPECTION

PROCEDURE


  1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY


    1. A005GQLE03
      Text in Illustration
      *1 1.1 mm (0.013 in.)
      *2 Ohmmeter
      *a

      Component without harness connected

      (Back-Up Light Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 - 2 Pushed Below 1 Ω
      1 - 2 Released 10 kΩ or higher

      If the result is not as specified, replace the back-up light switch assembly.