SHIFT PADDLE SWITCH INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here

PROCEDURE


  1. CONNECT NO. 1 SWITCH WIRE


    1. Connect the 2 No. 1 switch wire connectors to the 2 shift paddle switches (transmission shift switch assembly).

    2. A005JK7E01
      Text in Illustration
      *1 Clamp
      *a 0 to 40°
      *b 1 to 3 mm

      Install the 2 clamps as shown in the illustration.

    3. Engage the 4 guides to install the No. 1 switch wire.

  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)


    1. Engage the 4 pins and install the 2 shift paddle switches (transmission shift switch assembly) with the 2 screws.

      Torque:
      1.3 N*m  { 13 kgf*cm, 12 in.*lbf }

      Note

      Make sure that the brackets are securely installed.

  3. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)

    Click here

  4. INSTALL NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)

    Click here

  5. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  6. INSTALL STEERING PAD

    Click here

  7. INSTALL LOWER NO. 2 STEERING WHEEL COVER

    Click here

  8. INSPECT STEERING WHEEL CENTER POINT

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. INSPECT STEERING PAD

    Click here

  11. INSPECT SRS WARNING LIGHT

    Click here