MULTI-MODE MANUAL TRANSAXLE SYSTEM CALIBRATION


  1. SYNCHRONIZATION POSITION CALIBRATION

    For smoother shifting, the TCM learns the synchronization position of the transaxle gears. Perform the synchronization position calibration of the multi-mode manual transaxle while driving the vehicle after repairing system components.

    Tech Tips


    • If clutch fluid line parts are installed, bleed the air from the lines before performing initialization Click here.

    • When replacing the following parts, proceed with the operation in the order listed in the table below.

    Part Installed Operation Order See Procedure

    • Transaxle assembly

    • Transaxle parts (inside gear box)

    • TCM

    1. Initialization of Multi-Mode Manual Transaxle System

    [Initialization of ECU]

    Click here

    2. Learning of Multi-Mode Manual Transaxle System

    Click here

    3. Synchronization Position Calibration See below

    • Shift and select actuator

    • Shift stroke sensor

    • Select stroke sensor

    1. Initialization of Multi-Mode Manual Transaxle System

    [Initialization of transmission]

    Click here

    2. Learning of Multi-Mode Manual Transaxle System

    Click here

    3. Synchronization Position Calibration See below

    • Clutch actuator

    • Clutch stroke sensor

    • Clutch disc and clutch cover

    • Clutch release with bearing cylinder assembly

    • Flywheel

    • Crankshaft

    1. Initialization of Multi-Mode Manual Transaxle System

    [Initialization of clutch]

    Click here

    2. Learning of Multi-Mode Manual Transaxle System

    Click here

    Note

    Do not clear (initialize) parts other than those specified in the "Part installed" column in the table above.


    1. While driving the vehicle in M-mode, shift up and down between 1st and 6th at the vehicle speeds specified below.

    2. Check that the gears shift smoothly.

      Recommended Gear Shifting Speeds
      Gear Change Gear Position Vehicle Speed
      Up shift 1st → 2nd 27 to 41 km/h (16.8 to 25.5 mph)
      2nd → 3rd 49 to 77 km/h (30.4 to 47.8 mph)
      3rd → 4th 72 to 112 km/h (44.7 to 69.6 mph)
      4th → 5th 97 to 151 km/h (60.3 to 93.8 mph)
      5th → 6th 97 to 206 km/h (60.3 to 128.0 mph)
      Down shift 2nd → 1st 27 to 33 km/h (16.8 to 20.5 mph)

      Tech Tips


      • Leave an interval of more than 2 seconds between gear changes.

      • If there is a shock when changing gears after the synchronization position calibration, perform the synchronization position calibration again.