SHIFT AND SELECT ACTUATOR INSTALLATION

PROCEDURE


  1. INSTALL RING PIN


    1. A005L44E02
      Text in Illustration
      *a Protrusion Height

      Using a plastic-faced hammer tap in 2 new ring pins to the specified protrusion height.

      Protrusion height
      5.2 to 5.8 mm (0.205 to 0.228 in.)

  2. INSTALL TRANSMISSION BREATHER SUB-ASSEMBLY


    1. Connect the breather hose onto the shift and select actuator.

    2. Install the transmission breather sub-assembly with the bolt.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  3. INSTALL SHIFT AND SELECT ACTUATOR ASSEMBLY


    1. A005IPIE02
      Text in Illustration
      *1 Seal Packing

      Apply FIPG to the shift and select actuator as shown in the illustration.

      FIPG
      Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent

      Note


      • Remove any oil from the contact surfaces.

      • Assemble the parts within 10 minutes of application. Otherwise, the packing (FIPG) material must be removed and reapplied.

    2. Install the wire harness clamp bracket with the 6 bolts.

      A005H9CE03
      Text in Illustration
      *1 Shift Sensor Shaft *2 Reverse Shift Head
      *3 Select Lever Gear *4 Inner Select Lever
      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

      Note


      • Securely engage the shift sensor shaft in the shift reverse shift head.

      • Securely engage the select lever gear engagement in the inner select lever.

    3. Connect the connectors and install the wire harness.

  4. INSTALL WIRE HARNESS CLAMP BRACKET


    1. Install the wire harness clamp bracket with the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

    2. Install the wire harness onto the wire harness clamp bracket.

  5. INSTALL AIR PIPE SUB-ASSEMBLY

    Click here

  6. INSTALL BATTERY CARRIER

    Click here

  7. INSTALL BATTERY TRAY

    Click here

  8. INSTALL BATTERY

    Click here

  9. BLEED CLUTCH LINE

    Click here

  10. PERFORM INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION ECU

    Click here

  11. PERFORM LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM

    Click here

  12. PERFORM SYNCHRONIZATION POSITION CALIBRATION

    Click here

  13. INSTALL AIR CLEANER BRACKET

    Click here

  14. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  15. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  16. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here