CLUTCH UNIT(for EC65A) INSPECTION

PROCEDURE


  1. INSPECT CLUTCH DISC ASSEMBLY

    A005KXW

    1. Using a vernier caliper, measure the rivet head depth.

      Minimum rivet depth
      0.3 mm (0.012 in.)

      If necessary, replace the clutch disc assembly.

    2. Install the clutch disc assembly onto the transaxle assembly.

      Tech Tips

      Insert the clutch disc assembly in the correct direction.

    3. A005GDY

      Using a dial gauge, measure the clutch disc assembly runout.

      Maximum runout
      0.8 mm (0.031 in.)

      If necessary, replace the clutch disc assembly.

  2. INSPECT CLUTCH COVER ASSEMBLY

    A005HKYE01

    1. Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

      Maximum
      A (Depth): 0.5 mm (0.020 in.)
      B (Width): 6.0 mm (0.236 in.)

      If necessary, replace the clutch cover assembly.

  3. INSPECT FLYWHEEL SUB-ASSEMBLY

    A005H0N

    1. Using a dial gauge, check the flywheel sub-assembly runout.

      Maximum runout
      0.1 mm (0.004 in.)

      If necessary, replace the flywheel sub-assembly.