CLUTCH ACTUATOR(for EC65A) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the multi-mode manual transaxle system. Read the precautionary notices concerning the multi-mode manual transaxle system before servicing Click here.

Note


  • If the clutch actuator assembly is removed from the multi-mode manual transaxle assembly, perform Learning of Multi-mode Manual Transaxle System.

  • When Learning of Multi-mode Manual Transaxle System is performed, the clutch disc assembly and clutch cover assembly have to be replaced as a set.

PROCEDURE


  1. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  2. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  4. REMOVE AIR CLEANER BRACKET

    Click here

  5. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A005H3W

      Disconnect the 2 connectors and separate the 2 wire harness clamps.

    2. A005GLY

      Remove the bolt and the wire harness clamp bracket.

  6. REMOVE BLEEDER CLUTCH RELEASE TUBE


    1. A005JWI

      Using a union nut wrench 10 mm, remove the bleeder clutch release tube and drain the brake fluid into the container.

  7. REMOVE CLUTCH ACTUATOR ASSEMBLY


    1. A005IHW

      Remove the 3 bolts and clutch actuator assembly.

    2. Drain brake fluid into the container.

  8. REMOVE NO.1 CLUTCH ACTUATOR BRACKET


    1. A005GK4

      Remove the bolt and wire harness clamp bracket.

    2. Remove the 4 bolts and No. 1 clutch actuator bracket from the manual transaxle assembly.