STOP AND START SYSTEM DTC CHECK / CLEAR

Tech Tips


  • DTCs, which are stored in the engine stop and start ECU, can be displayed on the intelligent tester. The intelligent tester can display current and pending DTCs.

  • Some DTCs are not stored if the engine stop and start ECU does not detect the same malfunction again during the second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.


  1. CHECK DTC


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Enter the following menus: Powertrain / Stop and Start / DTC.

    5. Check for DTC(s), and then save or write them down.

    6. Check the details of the DTC(s) Click here.

  2. CLEAR DTC


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester on.

    4. Enter the following menus: Powertrain / Stop and Start / DTC.

    5. Clear the DTCs.