CRUISE CONTROL SYSTEM Cruise SET Indicator Light Circuit

DESCRIPTION

When the ECM detects a cruise control main switch "on" signal from the cruise control main switch, it sends it to the combination meter through CAN communication. Then the cruise control SET indicator light turns on.

CAUTION / NOTICE / HINT

Note

First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.

PROCEDURE


  1. PERFORM ACTIVE TEST USING GTS (CRUISE CONTROL SET INDICATOR LIGHT)


    1. Using the GTS, perform the Active Test Click here.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Indicat. SET Cruise control SET indicator light OFF/ON Vehicle is stopped and engine is idling
      OK
      Indicator light turns on/off.

    NG

    GO TO METER / GAUGE SYSTEM Click here

    OK

  2. READ VALUE USING GTS (CRUISE CONTROL MAIN SWITCH)


    1. Using the GTS, read the Data List Click here.

      Cruise Control
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Cruise Control Cruise Control / OFF or ON

      OFF: Cruise Control not set

      ON: Cruise Control set

      		 -
      OK
      The display is as specified in the normal condition column.

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPLACE ECM Click here