STARTER INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Install the starter assembly with the 2 bolts.

      Torque:

      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   2. Connect the connector and clamp.

   3. Connect terminal 30 with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   4. Close the terminal cap.

2. INSTALL FLYWHEEL HOUSING SIDE COVER

   
   

   1. Insert the protruding portion into the end of the cylinder block and while pushing it along the cylinder block, fit the claw into the cylinder block.

      Note

      
      

      • Make sure that the claw makes a click sound, indicating that it fits tightly.

      • Replace the flywheel housing side cover with a new one if it does not fit tightly or is deformed.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected ( Click here)

   Torque:

   5.4 N*m  { 55 kgf*cm, 48 in.*lbf }