STARTER(w/ Stop And Start System) INSTALLATION

PROCEDURE


  1. INSTALL STARTER ASSEMBLY


    1. Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Connect the connector.

    3. Connect the terminal 30 with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    4. Close the terminal cap.

    5. Install the bracket with the bolt.

      Torque:
      8.4 N*m  { 85 kgf*cm, 74 in.*lbf }

    6. Engage the clamp.

  2. INSTALL FLYWHEEL HOUSING SIDE COVER


    1. A005M3OE01
      Text in Illustration
      *1 Protruding Portion

      Insert the protruding portion into the end of the cylinder block sub-assembly and while pushing it along the cylinder block sub-assembly, fit the claw into the cylinder block sub-assembly.

      Note


      • Make sure that the claw makes a click sound, indicating that it fits tightly.


      • Replace the claw with a new one if it does not fit tightly or is deformed.

  3. INSTALL BATTERY CARRIER

    Click here

  4. INSTALL BATTERY TRAY

    Click here

  5. INSTALL BATTERY

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  7. CLEAR NUMBER OF STARTER OPERATIONS

    Click here