STARTER(w/ Stop And Start System) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE BATTERY

    Click here

  4. REMOVE BATTERY TRAY

    Click here

  5. REMOVE BATTERY CARRIER

    Click here

  6. REMOVE FLYWHEEL HOUSING SIDE COVER


    1. A005HN3

      Disengage the claw by pulling it outward and remove the flywheel housing side cover.

  7. REMOVE STARTER ASSEMBLY


    1. A005GJA

      Disengage the clamp.

    2. Remove the bolt and bracket.

    3. A005MBI

      Open the terminal cap.

    4. Remove the nut and disconnect the terminal 30.

    5. Disconnect the connector.

    6. A005L3X

      Remove the 2 bolts and the starter assembly.