OIL LEVEL SENSOR INSTALLATION

PROCEDURE


  1. INSTALL ENGINE OIL LEVEL SENSOR

    A005JHWE02

    1. Temporarily tighten the oil level sensor with the 5 bolts.

    2. Fully tighten the bolts A first, and then tighten bolt B.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  2. INSTALL NO. 2 OIL PAN SUB-ASSEMBLY

    Click here

  3. ADD ENGINE OIL

    Click here

  4. CHECK ENGINE OIL LEVEL

    Click here

  5. INSPECT FOR OIL LEAK

    Click here

  6. INSTALL ENGINE UNDER COVER RH

    Click here

  7. INSTALL CENTER ENGINE UNDER COVER

    Click here

  8. OIL MAINTENANCE INFORMATION MODE RESET OPERATION

    Click here

  9. RESET UPPER OIL LEVEL


    1. Warm up the engine until the coolant temperature is 75°C to 86°C (167°F to 187°F).

    2. Drive the vehicle at 15 km/h (9 mph) or more with an engine speed of 1800 to 3000 rpm for 1 minute or more.

      Tech Tips

      If the upper level switch "off" signal continues for 10 seconds or more, the "oil level high side malfunction" monitor will be reset.