EXHAUST PIPE INSTALLATION

PROCEDURE


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. A005L7N

      Using a vernier caliper, measure the free length of the compression spring.

      Minimum length
      43.0 mm (1.693 in.)

      If the length is not as specified, replace the compression spring.

    2. A005HF7E22
      Text in Illustration
      *1 Gasket
      *2 Wooden Block

      Using a plastic hammer and a wooden block, tap in a new gasket until its surface is flush with the exhaust manifold.

      Note


      • Install the exhaust pipe gasket in the correct direction.

      • Do not damage the outer surface of the exhaust pipe gasket.

      • Do not reuse the exhaust pipe gasket.

      • Do not push in the gasket with the exhaust pipe when connecting it.

    3. Hang the front exhaust pipe assembly with the 3 exhaust pipe supports.

    4. Install the front exhaust pipe assembly with the 2 compression springs and 2 bolts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  2. INSTALL TAIL EXHAUST PIPE ASSEMBLY


    1. Install a new gasket onto the front exhaust pipe assembly.

    2. Hang the tail exhaust pipe assembly with the 2 exhaust pipe supports.

    3. Install the tail exhaust pipe assembly with the 2 bolts.

      Torque:
      32 N*m  { 326 kgf*cm, 24 ft.*lbf }

  3. INSTALL FRONT FLOOR CENTER BRACE


    1. Install the front floor center brace with the 2 bolts.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

  4. INSPECT FOR EXHAUST GAS LEAK