REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

      Note

      Keep the lip free of foreign matter.

    2. A005KTDE01
      *1 0 to -1 mm
      *2 (0 to -0.04 in.)

      Using SST and hammer, tap in the oil seal until its surface is flush with the cylinder block and oil pan .

      SST
      09223-56010

      Note


      • Do not tap the oil seal at an angle.

      • Wipe off extra grease from the crankshaft.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. Using SST, hold the crankshaft.

      SST
      09960-10010   ( 09962-01000, 09963-01000 )

    2. Clean the bolts and bolt holes.

    3. A005K7QE01
      Text in Illustration
      *1 Front Drive Plate Spacer
      *2 Drive Plate and Ring Gear
      *3 Rear Drive Plate Spacer
      A005GO2 Engine Side
      A005IBX Transaxle Side

      Install the front drive plate spacer.

    4. Install the drive plate and rear drive plate spacer onto the crankshaft.

      Tech Tips


      • The front drive plate spacer is reversible.

      • As the drive plate and ring gear and the rear drive plate spacer are not reversible, make sure to install them in the direction as shown in the illustration.

    5. A005HCSE38
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 end threads at the end of each of the 6 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three bond 1324 or equivalent
    6. A005M7SE08

      Install and uniformly tighten the 6 bolts in several steps in the sequence shown in the illustration.

      Torque:
      88 N*m  { 897 kgf*cm, 65 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate.

  3. INSTALL CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY

    (See page MULTIDRIVE / CVT (K310) > CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY > INSTALLATION)