DRIVE BELT INSTALLATION

PROCEDURE

1. INSTALL FAN AND GENERATOR V BELT

   
   
   1. 

      Text in Illustration

      *a	w/o Air Conditioning System
      *b	w/ Air Conditioning System

      Install the fan and generator v belt.

   2. If it is difficult to install the fan and generator v belt, perform the following procedure:

      
      

      1. Put the fan and generator v belt on every pulley except the tensioner pulley as shown in the illustration.

      2. Release the V-ribbed belt tension by turning the V-ribbed belt tensioner counterclockwise, and put the fan and generator v belt on the tensioner pulley.

         Note

         
         

         • Put the backside of the fan and generator v belt on the V-ribbed belt tensioner pulley.

         
         

         • Check that the fan and generator v belt is properly set to each pulley.

   3. 

      Text in Illustration

      *a	counterclockwise

      Turn the V-ribbed belt tensioner counterclockwise and remove the 5 mm hexagon wrench.

   4. After installing the fan and generator v belt, check that it fits properly in the ribbed grooves. Confirm that the fan and generator v belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

2. INSTALL ENGINE UNDER COVER RH

   Click here

3. INSTALL INLET NO. 1 AIR CLEANER

   Click here

4. INSTALL NO. 1 ENGINE COVER

   Click here