ACCELERATOR PEDAL ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT ACCELERATOR PEDAL ASSEMBLY


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine / Data List / Accel Sensor Out No.1, Accel Sensor Out No.2.

    5. Read the value displayed on the tester.

      Accelerator Position No. 1 Standard Voltage
      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V
      Accelerator Position No. 2 Standard Voltage
      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 4.7 V

      If the result is not as specified, check the accelerator pedal assembly, wire harness or ECM.