AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR


    1. A005H9QE02
      Text in Illustration
      *a Fulcrum Length 300mm
      *b Fulcrum Length 30mm

      Using SST, install the air fuel ratio sensor.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Click here.

      • This torque value is effective when SST is parallel to the torque wrench.

      • Perform "Inspection After Repairs" after replacing the air fuel ratio sensor Click here.

    2. Connect the air fuel ratio sensor connector.

    3. Install the wire harness to the wire harness bracket.

  2. INSTALL OUTER COWL TOP PANEL

    Click here

  3. INSTALL INNER COWL TOP TO COWL BRACE

    Click here

  4. INSTALL COWL TOP REINFORCEMENT INNER LOWER

    Click here

  5. INSTALL COWL TOP INSIDE CORNER PANEL RH

    Click here

  6. INSTALL FRONT AIR SHUTTER SEAL RH

    Click here

  7. INSTALL FRONT NO. 1 VENTILATOR SEAL

    Click here

  8. INSTALL WINDSHIELD WIPER MOTOR AND LINK

    Click here

  9. INSPECT FOR EXHAUST GAS LEAK