MANIFOLD ABSOLUTE PRESSURE SENSOR ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT TURBO PRESSURE SENSOR

    A005JA0E08
    Text in Illustration
    *a

    Front of wire harness connector

    (to Turbo Pressure Sensor)

    1. Inspect the power source voltage.


      1. Disconnect the sensor connector.

      2. Measure the voltage according to the value(s) in the table below.

        Standard Voltage
        Tester Connection Switch Condition Specified Condition
        3 (VC) - 1 (E2) Ignition switch ON 4.5 to 5.5 V

      3. Turn the ignition switch off.

      4. Reconnect the sensor connector.

    2. Check the vacuum and pressure.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to ON and turn the intelligent tester on.

      3. Enter the following menus: Powertrain / Engine / Data List / Map and Atmosphere Pressure.

      4. Read the value.

        OK
        Condition Map and Atmosphere Pressure Value
        No pressure applied Same as atmospheric pressure
        Vacuum applied Becomes vacuum
        Pressure applied Becomes pressurized

        If the result is not as specified, replace the sensor.