ECD SYSTEM, Diagnostic DTC:P0600, P0604, P0605, P0606, P0607, P060A, P060B, P060D, P0611, P061A, P061B, P061C, P062F

DTC Code DTC Name
P0600 Serial Communication Link
P0604 Random Access Memory (RAM)
P0605 Internal Control Module Read Only Memory (ROM) Error
P0606 ECM / PCM Processor
P0607 Control Module Performance
P060A Internal Control Module Monitoring Processor Performance
P060B Internal Control Module A/D Processing Performance
P060D Internal Control Module Accelerator Pedal Position Performance
P0611 Fuel Injector Control Module Performance
P061A Internal Control Module Torque Performance
P061B Internal Control Module Torque Calculation Performance
P061C Internal Control Module Engine RPM Performance
P062F Internal Control Module EEPROM Error

DESCRIPTION

P0600, P0604, P0605, P0606, P0607, P060A, P060B, P060D, P0611, P061A, P061B, P061C, P062F
DTC Detection Drive Pattern DTC Detection Condition Trouble Area

One of following conditions is met:


  • Ignition switch ON

  • Engine Idling

  • Drive the vehicle with a stop-and-go city drive pattern for more than 15 minutes.

ECM internal error

(1 trip detection logic)

 ECM

CAUTION / NOTICE / HINT

Note

When replacing the ECM, the ECM needs Registration and Initialization Click here.

Tech Tips

When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the intelligent tester. Then after installing the new ECM, perform all of the initializations/registrations for the "Learning Values Write" function by following the instructions shown on the tester display.

PROCEDURE


  1. REPLACE ECM


    1. Replace the ECM Click here.


    NEXT

  2. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the intelligent tester to the DLC3.

    2. Clear the DTCs Click here.

    3. Turn the ignition switch off and wait for 30 seconds or more.

    4. Turn the ignition switch to ON.

    5. Start the engine.

    6. Drive the vehicle with a stop-and-go city drive pattern for more than 15 minutes.

    7. Enter the following menus: Powertrain / Engine and ECT / DTC.

    8. Confirm that the DTC is not output again.


    NEXT

    END