RELAY ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT H-LP/US-DRL RELAY

   

   Text in Illustration

   *a	Component without harness connected (H-LP/US-DRL Relay)

   
   

   1. Remove the h-lp/us-drl relay from the engine room sub relay block.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 3 - 5 Voltage is not applied between terminal 1 and 2 10 kΩ or higher Voltage is not applied between terminal 1 and 2 Below 1 Ω

      If the result is not as specified, replace the relay.

2. INSPECT DIM RELAY

   

   Text in Illustration

   *a	Component without harness connected (DIM Relay)

   
   

   1. Remove the dim relay from the engine room sub relay block.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 3 - 4 Battery voltage not applied to terminal 1 and 2 Below 1 Ω Battery voltage applied to terminal 1 and 2 10 kΩ or higher 3 - 5 Battery voltage not applied to terminal 1 and 2 10 kΩ or higher Battery voltage applied to terminal 1 and 2 Below 1 Ω

      If the result is not as specified, replace the relay.

3. INSPECT FR FOG RELAY

   

   Text in Illustration

   *a	Component without harness connected (FR FOG Relay)

   
   

   1. Remove the fr fog relay from the No. 5 relay block.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 3 - 5 Battery voltage not applied to terminal 1 and 2 10 kΩ or higher Battery voltage applied to terminal 1 and 2 Below 1 Ω