LIGHTING SYSTEM OPERATION CHECK

Note

Perform this inspection with the customize parameters at the initial setting.


  1. AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK (w/ Rear Fog Light)


    1. Turn the ignition switch to ON.

    2. Turn the light control switch to the AUTO position.

    3. Cover the light control sensor.

    4. Check that the taillights and low beam headlights come on.

    5. Uncover the light control sensor.

    6. Check that the low beam headlights and taillights go off.

  2. AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK (w/o Rear Fog Light)


    1. Turn the ignition switch to ON.

    2. Turn the light control switch to the AUTO position.

    3. Cover the light control sensor little by little.

    4. Check that the taillights and low beam headlights come on in sequence.

    5. Uncover the light control sensor little by little.

    6. Check that the low beam headlights and taillights go off in sequence.

  3. LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK (w/ Rear Fog Light)


    1. When light control switch in AUTO position.


      1. Turn the ignition switch to ON.

      2. Turn the taillights, headlights, rear fog lights and front fog lights* on.

      3. Turn the ignition switch off.

      4. Check that all of lights go off immediately.

    2. When light control switch in TAIL or HEAD position.


      1. Turn the ignition switch to ON.

      2. Turn the taillights, headlights, rear fog lights and front fog lights* on.

      3. Turn the ignition switch off.

      4. Check that the headlights and front fog lights* go off immediately.


    • *: w/ Front Fog Light

  4. LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK (w/o Rear Fog Light)


    1. When light control switch in TAIL, HEAD or AUTO position.


      1. Close the driver side door.

      2. Turn the ignition switch to ON.

      3. Turn the taillights and headlights on.

      4. Turn the ignition switch off.

      5. Open the driver side door.

      6. Check that all of lights go off immediately.

  5. DAYTIME RUNNING LIGHT SYSTEM OPERATION CHECK (w/ Rear Fog Light)


    1. Turn the light control switch to off.

    2. Start the engine.

    3. Release the parking brake.

    4. Check that the daytime running lights come on.

  6. FOLLOW ME HOME SYSTEM OPERATION CHECK (w/ Rear Fog Light)


    1. Turn the light control switch off or to AUTO position.

    2. Turn the ignition switch off.

    3. Pull the dimmer switch to flash the headlights once.

    4. Check that the low beam headlights come on for a certain period.

  7. AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK (w/ HID Headlight)


    1. Check that the initialization (determination of the initial position) of the headlight leveling motor (headlight unit) is performed when the ignition switch is turned to ON.

    2. Check that the headlight beam level control system warning light in the combination meter assembly comes on for approximately 3 seconds when the ignition switch is turned to ON, and then turns off.

    3. Check that the headlight moves when all of the following conditions are met: 1) the rear of the vehicle is moved up or down, 2) the engine is running, 3) the vehicle is stopped, and 4) the light control switch is in the head position.

      Note

      Make sure to change the vehicle height slowly.

  8. INSPECT BATTERY SAVER (w/ Rear Fog Light or w/ Automatic Light Control System)


    1. With the ignition switch off, turn the light control switch to TAIL or HEAD to illuminate the headlights.

    2. Check that the headlights and taillights turn off when the doors and the light control switch remain in the same condition for 20 minutes.