ГЕНЕРАТОР СНЯТИЕ

PROCEDURE

1. PRECAUTION

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE UPPER RADIATOR SUPPORT SEAL

   Click here

4. REMOVE BATTERY

   Click here

5. REMOVE BATTERY TRAY

6. REMOVE V-BANK COVER SUB-ASSEMBLY

   Click here

7. REMOVE FAN AND GENERATOR V BELT

   Click here

8. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

   
   

   1. 

      for Integrated Type:

      Remove the bolt and No. 2 idler pulley.

   2. for Separate Type:

      Remove the bolt, No. 2 idler pulley cover plate, No. 2 idler pulley and idler pulley cover plate.

9. REMOVE WIRING HARNESS CLAMP BRACKET

   
   

   1. 

      Detach the clamp.

   2. Remove the bolt and wiring harness clamp bracket.

10. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

    Click here

11. REMOVE GENERATOR ASSEMBLY

    
    

    1. 

       Open the terminal cap.

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the generator connector from the generator assembly.

    4. 

       Remove the 2 bolts and disconnect the wire harness.

    5. 

       Detach the wire harness clamp.

    6. Remove the bolt from the cylinder block.

    7. 

       Remove the 2 bolts and generator assembly.

    8. 

       Remove the bolt and generator bracket.