СИСТЕМА ЗАРЯДКИ АККУМУЛЯТОРНОЙ БАТАРЕИ Charging Failure

PROCEDURE

1. CHECK GENERATOR WITH CLUTCH PULLEY (ON-VEHICLE INSPECTION)

   
   

   1. Start the engine and visually check if the fan of the generator rotor assembly located inside the generator assembly is operating.

      OK
      The fan of the generator rotor assembly is operating.

      Result
      Result OK NG

   
   

   NG

   REPLACE GENERATOR WITH CLUTCH PULLEY Click here

   OK

2. CHECK GENERATOR WITH CLUTCH PULLEY (UNIT INSPECTION)

   
   

   1. Remove the generator assembly.

      Click here

   2. Check the installation condition of the generator pulley cap.

      OK
      The generator pulley cap is not loose or missing.

   3. Check for grease leaks (for wet pulley) or particle formation due to friction (for dry pulley).

      OK
      No grease leaks (for wet pulley) or large build-up of particles (for dry pulley).

   4. Check the generator pulley with clutch for misalignment (interference with the generator assembly).

      OK
      The generator pulley with clutch is correctly aligned (no interference with the generator assembly).

   5. 

      Turn the generator pulley with clutch clockwise and counterclockwise by hand and check for noise.

      OK
      Noise does not occur when turned in both directions.

   6. Turn the generator pulley with clutch clockwise and counterclockwise by hand and visually check for runout.

      OK
      The generator pulley with clutch does not have runout.

   7. 

      *a	Protective Tape

      Using a screwdriver, hold the fan of the generator rotor assembly located inside the generator assembly in place and check that the generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.

      OK
      The generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.

      Result
      Result OK NG

   
   

   OK

   REPAIR OR REPLACE GENERATOR ASSEMBLY Click here

   NG

   REPLACE GENERATOR WITH CLUTCH PULLEY Click here