ГЕНЕРАТОР РАЗБОРКА

Информация добавлена 08-08-2017

PROCEDURE


  1. REMOVE GENERATOR PULLEY CAP


    1. A01A8EB

      Using a screwdriver, remove the generator pulley cap.

  2. REMOVE GENERATOR WITH CLUTCH PULLEY


    1. Mount the generator in a vise between aluminum plates.

    2. A01A5FTC03
      *1 Rotor Shaft

      Install SST (A) and SST (B) to the generator with clutch pulley as shown in the illustration.

      SST
      09820-63021

      Note

      Securely attach SST to the generator with clutch pulley and generator rotor shaft.

    3. A01A78FC02
      *a Hold
      B001T99 Turn

      Use a wrench to hold SST (A) and turn SST (B) counterclockwise to loosen the generator with clutch pulley.

      Note

      Be careful as the generator with clutch pulley or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

    4. Remove SST from the generator.

    5. Remove the generator with clutch pulley from the rotor shaft.

  3. REMOVE GENERATOR REAR END COVER


    1. A01A43Q

      Remove the nut and cord clip.

    2. A01A7RG

      Remove the 3 nuts and generator rear end cover.

  4. REMOVE TERMINAL INSULATOR


    1. A01A5W9

      Remove the terminal insulator from the generator coil.

  5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    1. A01A4JW

      Remove the 2 screws and generator brush holder from the generator coil.

  6. REMOVE GENERATOR COIL ASSEMBLY


    1. A01A8EX

      Remove the 4 bolts.

    2. A01A3MTC02
      *a Hold
      B001T99 Turn

      Using SST, remove the generator coil.

      SST
      09950-40011   ( 09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011 )

  7. REMOVE GENERATOR ROTOR ASSEMBLY


    1. A01A80A

      Remove the generator washer.

    2. A01A8D0

      Remove the generator rotor.

  8. INSPECT GENERATOR DRIVE END FRAME BEARING


    1. A01A386

      Check that the drive end frame bearing is not rough or worn.

      If necessary, replace the generator drive end frame bearing.

  9. REMOVE GENERATOR DRIVE END FRAME BEARING


    1. A01A8JO

      Remove the 4 screws and retainer plate from the drive end frame.

    2. A01A6IRN05

      Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.

      SST
      09950-60010   ( 09951-00250 )
      09950-70010   ( 09951-07100 )